Cisco 7920 Administration Manual page 143

Chapter 6 Configuring the Wireless Network Settings on the Cisco Wireless IP Phone 7920
The display provides the following information about the APs.
AP
Channel Channel State
1
6
11
Step 5 To see more information about an AP, scroll to the desired line and press Detail.
The following information appears for the specific AP.
SSID: abcd1234
Channel:6 (C)
RSSI:51 CU:0
MAC:000a11b22c33444 (C)
Note
Step 6 To verify the ability to roam between APs, walk through all areas where phones
will be used and take readings. Approach areas from different directions to assure
successful roaming conditions.
Adjust AP and antenna placement and AP power settings to meet the ideal
Step 7
wireless voice environment as described in
Voice Environment, page
In addition to the Cisco Wireless IP Phone 7920 site survey utility, you can also
use the Cisco Aironet Client Utility Site Survey Utility from a laptop PC. Refer
to the section on "Performing a Site Survey" in the
Client Adapters Installation and Configuration Guide
Related Topic
•
Cisco Wireless IP Phone 7920 Administration Guide for Cisco CallManager Release 3.3 or Later
OL-3930-02
Active (A)
Connected (C)
Active (A)
The complete SSID and the MAC address are provided. When two or
more APs are on the same connected channel, the (C) next to the MAC
address indicates that the phone is connected to this AP.
6-18.
Site Survey Verification Steps, page 6-15
Performing a Site Survey Verification
Received Signal
Strength
SSID Indication (RSSI)
abcd1234 20
abcd1234 51
abcd1234 10
Requirements for an Optimal Wireless
Channel Connect
Utilization AP
0
0 *
0
Cisco Aironet Wireless LAN
for your system.
6-17