Cisco 7920 Administration Manual page 122

Verifying or Entering Network Settings
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Assigning a Subnet Mask
Step 1
Step 2
Step 3
Step 4
Step 5
Cisco Wireless IP Phone 7920 Administration Guide for Cisco CallManager Release 3.3 or Later
5-10
Chapter 5
Before you can assign an IP address, you must disable DHCP. For instructions,
see the "Disabling DHCP" section on page
Procedure
Press the Menu softkey.
Choose Network Config > DHCP Enable/Disable > Disable
Scroll to Static Settings and press Select.
The Static Settings menu options display.
Scroll to IP Address and press Select.
Press the Edit softkey.
Enter or modify the IP address.
For information about entering values, see the
the Network Configuration Menu" section on page
Press Back to return to the Static Settings options.
The subnet mask is used to partition the IP address into a network and a host
identifier. The subnet mask is used to mask a portion of the IP address so that
TCP/IP can distinguish the network ID from the host ID.
Before you can assign a subnet mask, you must disable DHCP. For instructions,
see the "Disabling DHCP" section on page
Procedure
Press the Menu softkey.
Choose Network Config > DHCP Enable/Disable > Disable
Scroll to Static Settings and press Select.
The Static Settings menu options display.
Scroll to Subnet Mask, then press Select.
Press the Edit softkey.
Configuring Network Settings on the Cisco Wireless IP Phone 7920
5-8.
"Guidelines for Editing Settings in
5-8.
5-3.
OL-3930-02