Support For The Cisco 7920 Phone Type - Cisco 7920 Administration Manual

Adding Phones to the Cisco CallManager Database

Support for the Cisco 7920 Phone Type

Cisco Wireless IP Phone 7920 Administration Guide for Cisco CallManager Release 3.3 or Later
2-14
Chapter 2 Preparing to Install the Cisco Wireless IP Phone 7920 on Your Wireless Network
• Adding Phones with Auto-Registration and TAPS, page 2-18
Adding Phones with Cisco CallManager Administration, page 2-18
•
Adding Phones with BAT, page 2-19
•
Table 2-3 provides an overview of these methods for adding phones to the
Cisco CallManager database.
Table 2-3 Methods for Adding Phones to the Cisco CallManager Database
Method
Auto-registration
Auto-registration with TAPS
Using the Cisco CallManager
Administration only
Using BAT
Cisco CallManager release 3.3(3) SR1 and later includes support for the
Cisco 7920 phone type in the Cisco CallManager Administration application.
(Previously, there was no phone type for this phone and you had to configure it as
a Cisco IP Phone 7960.)
If you upgrade to Cisco CallManager release 3.3(3) SR1 and later, you can choose
the Cisco 7920 phone type when adding the wireless phone. However, if you
perform the upgrade and have Cisco wireless phones on your network that were
previously configured as Cisco IP Phone 7960s, you will need to remove those
Requires MAC
Address? Notes
No Results in automatic
assignment of directory
numbers
No Requires auto-registration and
the Bulk Administration Tool
(BAT); updates information in
the Cisco IP Phone and in
Cisco CallManager
Administration
Yes Requires phones to be added
individually
Yes Allows for simultaneous
registration of multiple phones
OL-3930-02