Configuring The Wlan Controller Eap-Request And Eapol-Key Timeouts - Cisco 7925G Deployment Manual

"Dot11 phone" will enable the 2 Cisco versions, where "dot11 phone dot11e" will enable both CCA versions (802.11e and
Cisco version 2). It is recommended to enable "dot11 phone dot11e".
Below are the commands to change the QBSS max threshold for each platform type.
Cisco Unified Wireless LAN Controller = "config advanced 802.11b 7920VSIEConfig call-admission-limit <value>"
Cisco Autonomous Access Point = "dot11 phone cac-thresh <value>"

Configuring the WLAN Controller EAP-Request and EAPOL-Key Timeouts

If using EAP, the EAP-Request Timeout on the Cisco Unified Wireless LAN Controller should be set to at least 20 seconds.
In later versions, the default EAP-Request Timeout was changed from 2 to 30 seconds.
The default timeout on the Cisco ACS server is 20 seconds.
To change the EAP-Request Timeout on the Cisco Unified Wireless LAN Controller, telnet or SSH to the controller and enter
the following command.
(Cisco Controller) >config advanced eap request-timeout 30
(Cisco Controller) >show advanced eap
EAP-Identity-Request Timeout (seconds)........... 30
EAP-Identity-Request Max Retries................. 2
EAP Key-Index for Dynamic WEP.................... 0
Cisco Unified Wireless IP Phone 7925G Deployment Guide 55