Siemens CLINITEK Status+ Operator's Manual page 161

Term
authorized operator
auto-check
automatic strip
identification
baud rate
calibration
cancel
comment
configuration
conventional unit
control
countdown
Custom set up
data entry
data entry box
CLINITEK Status+ Analyzer Operator's Guide
Definition
Operators who can perform certain tasks,
where they gain access to the analyzer by
entering their operator ID to perform those
tasks.
Performs automatic strip quality checks and
provides results in about 1 minute.
Automatically identifies an ID band strip type
with no need to select it from a menu.
The speed of data transmission in bits per
second (bps) between the analyzer and a
remote device.
The analyzer reads the white calibration bar
at the appropriate wavelengths to ensure
accurate test results.
To end a sequence or anoperation.
A notation the operator enters for a QC test
result.
System hardware and software settings that
adjust or configure some aspect of the
analyzer.
Unit of measurement for test results.
Objects that display on the software UI that
the operator can manipulate. Buttons,
boxes, and optionbuttons are examples of
controls.
Solution containing a known level of
analytes.
A numeric display that indicates the amount
of time left in an operation.
Patient, operator, and sample appearance
custom settings.
The act of entering data such as a patient or
operator ID into the analyzer.
A software UI object which displays the data
that the operator entered.
161