Leveling - FLASHFORGE 3D PRINTER CREATOR PRO 2 User Manual

2.3.2 Leveling

Clearing the remaining materials on the nozzle first to avoid leveling fails.
Filament Level
Setting Status
1. Tap [Tools]-[Level] to start leveling. The machine will finish homing first.
Screw the three nuts tnder the platform
counterclockwise until they are tight, then
tap the [Next].
2. After stop movement of extruder and platform, tighten the three nuts below the
platform counterclockwise (To avoid scratch build plate by extruder and it is important
action)
Please adjust the front thumb screw under
Platform when stop.
3. Choose one extruder and move it to the first nut by hand. Place a paper under the
extruder and tighten the nut to reduce the distance between extruder and platform.
Gently move the paper and feel the fraction. If move the paper with gent fraction, it is a
suitable distance between extruder and platform. Finished the first place, and repeat
the same actions in the second and third nut.
Note: the small distance between the extruder and platform causes removing printed
objects hard, while big distance causes adhesion fails or wrapping.
Home Manual
About
Next
Next
Please wait, device is homing.
15
Next