FLASHFORGE 3D PRINTER CREATOR PRO 2 User Manual page 27

Screw the three nuts tnder the platform
counterclockwise until they are tight, then
tap the [Next].
After stop movement of extruder and platform, tighten the three nuts below the platform
counterclockwise (To avoid scratch build plate by extruder and it is important action)
Please adjust the front thumb screw under
Platform when stop.
Choose one extruder and move it to the first nut by hand. Place a paper under the
extruder and tighten the nut to reduce the distance between extruder and platform.
Gently move the paper and feel the fraction. If move the paper with gent fraction, it is a
suitable distance between extruder and platform. Finished the first place, and repeat the
same actions in the second and third nut.
Homing! Please wait...
[Home]
Tap [Home] and machine come back to the zero of movement.
Next
Next
Yes Cancel
Level Adjustment Finished!
Homing Finished.
25
Finish
Yes Cancel