Bowflex LateralX LX5 Service Manual page 89

9. Connect the Console Mast cables to the new Lower Lateral Data Cable
and Lower Resistance Data Cable.
NOTICE: Align the clips on the cable connectors and make sure the
connectors lock. Do not crimp the cables.
10. Carefully route the new Lower Resistance Data Cable and connect it
to the Speed/Direction Sensor wire,Servo Motor wire and the Power wire
at the Servo Motor.
NOTICE: Be sure the connectors lock. Do not crimp the cables.
11. Carefully route the new Lower Lateral Data
Cable, and align and connect the connector to
the connection on the PCBA Slim Control Board.
NOTICE: Be sure the connectors lock. Do not
crimp the cables.
Reinstall the PCBA cover.
12. The remaining assembly steps are the reverse procedure.
Note:
Shroud with the Push Fasteners and move the Right Shroud into
position. Push the Shrouds together so that the Push Fasteners
are fully seated. Using a #2 Phillips screwdriver, install the 6
screws.
Self-tapping screws attach the Shrouds to the Frame.
Re-install the Mast Gasket.
Be sure the Handlebar Links are tilted forward. Put the Wave Washers on
the pivot rods.
Be aware that the Handlebar Arms are top heavy, and will
want to pivot when attached onto the Pivot Rod. Be sure to
stay out of the path of the Handlebar.
Align the Handlebar Arm assembly with the pivot rod and attach the lower
Handlebar Arm to the Handlebar Link
13. Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Lower Lateral Data Cable
89
Lower Resistance Data Cable