Bowflex LateralX LX5 Service Manual page 54

12. To remove the Mid Pedal Arm, use the dead blow hammer (or mallet)
to strike it on the surface closer to the main frame alternately on either
side of the bearing housing until you drive it off the Crank arm. Set the old
Mid Pedal Arm safely aside.
Note: It may be helpful to rotate the Mid Pedal Arm to allow easier access
to the other side of the bearing housing. Be sure the Mid Pedal Arm
stays aligned on the Crank arm as you remove it, to avoid damage
to the Crank.
13. Using a #2 Phillips screwdriver, remove the indicated screws from the
Crank Shrouds. Remove the Crank Shrouds and set them safely aside.
14. Using a #2 Phillips screwdriver, remove the 5 indicated screws from
the Right Lower Shroud. Carefully remove the Right Lower Shroud and
set it safely aside.
Mid Pedal Arm
54
Bearing
housing
Bearing