Bowflex LateralX LX5 Service Manual page 72

34. Put the Right Drive Belt onto the Crank pulley. Put the Drive Belt in
position around the Tensioner Pulley (6) and Second Stage Crank belt
pulley (7). Be sure that the upper portion of the Drive Belt is under the
bearings on the Tensioner Pulley.
35. Turn the crank 3 to 5 turns in the direction of the arrow, and check
the tension. On the lower part of the belt, twist the belt at the midpoint
between the pulleys. The belt should not twist more than 45 degrees.
!
clear of all pinch hazards
when you turn the Crank.
If necessary, tighten more. Refer
to the "Adjust the Belt Tension"
procedure in this manual.
36. Using a Phillips screwdriver, attach the Left Lower Shroud to the main
frame. First, tighten the screw in position A, then tighten the screw in
position B, and then tighten the screws in the other positions.
A
72
Crank
pulley
6
7
M4 x 40
M5 x 40
B