Bowflex LateralX LX5 Service Manual page 69

19. Using a #2 Phillips Screwdriver, remove the 4 screws that attach the
the top screws (5b). Set the screws safely aside.
Servo wheel
5b (X2)
5a (X2)
20. Using an 8mm open end wrench, loosen the indicated nut (1) on the
Flywheel cable two turns. Observe the routing of the cable around the
white nylon servo wheel. Carefully pull the cable straight down out of the
mounting bracket (2) and move the cable toward the servo wheel. Pull
down to remove the "barrel" end (3) of the cable from its slot (4) on the
servo wheel. Remove the Servo Motor and set it safely aside.
Note: If you are not replacing the Flywheel, you can skip this step.
Flywheel cable
69
Servo wheel
Flywheel
cable
1
3
2
4