Bowflex LateralX LX5 Service Manual page 137

6. Using a #2 Phillips Screwdriver, remove the 2 screws that attach the
Speed/Direction Sensor to the frame, and set them safely aside. Remove
the old Speed/Direction Sensor and set it safely aside.
7. Using a #2 Phillips Screwdriver, attach the new Speed/
Direction Sensor to the frame.
NOTICE: Do not crimp the cables. Be sure the routing for
the new Speed/Direction Sensor wire and other
wiring is correct to prevent interference from
moving parts.
Note: Before fully attaching the Shrouds, verify that the
Speed/Direction Sensor and Speed Sensor Magnet
on the Drive Pulley do not touch.
8. The remaining assembly steps are the reverse procedure.
Note: Put the Right Upper Shroud in position. Align the Push Fasteners.
Push the Shrouds together so that the Push Fasteners are fully
seated. Using a #2 Phillips screwdriver, re-install the 3 screws.
Self-tapping screws attach the Shroud to the Frame.
Re-install the Mast Gasket.
Be sure the Handlebar Link is tilted forward. Put the Wave Washer on the
pivot rod.
Be aware that the Handlebar Arms are top heavy, and will
want to pivot when attached onto the Pivot Rod. Be sure to
stay out of the path of the Handlebar.
Align the Handlebar Arm assembly with the pivot rod and attach the lower
Handlebar Arm assembly fully onto the pivot rod and install the hardware
9. Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
137
Screws
Speed/direction
sensor