Bowflex LateralX LX5 Service Manual page 110

13. Install the indicated screw and nut:
LX3/LX3i—move the Swing Arm end into the Mid Pedal Arm bracket.
Using two 8" or longer adjustable wrenches (or 24mm or 15/16" socket
nut.
LX5/LX5i—move the Adjustable Arm to engage the Mid Pedal Arm
bracket. Using an 24mm or 15/16" socket wrench (inside of arm) and
24mm or 15/16" open end wrench or adjustable wrench (outside of arm),
install the indicated screw and nut.
Completely tighten the nut, or torque to 120 Nm (89 ft-lb).
14. Repeat steps11-13 for the Right Mid Pedal Arm.
15. The remaining assembly steps are the reverse procedure.
Be sure the Handlebar Links are tilted forward. Put the Wave Washers on
the pivot rods.
Be aware that the Handlebar Arms are top heavy, and will
want to pivot when attached onto the Pivot Rod. Be sure to
stay out of the path of the Handlebar.
Align the Handlebar Arm assembly with the pivot rod and attach the lower
Handlebar Arm to the Handlebar Link
16. Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
110