Bowflex LateralX LX5 Service Manual page 133

11. The remaining assembly steps are the reverse procedure.
Note: Put the Right Upper Shroud in position. Align the Push Fasteners.
Push the Shrouds together so that the Push Fasteners are fully
seated. Using a #2 Phillips screwdriver, re-install the 3 screws.
Self-tapping screws attach the Shroud to the Frame.
Re-install the Mast Gasket.
Be sure the Handlebar Link is tilted forward. Put the Wave Washer on the
pivot rod.
Be aware that the Handlebar Arms are top heavy, and will
want to pivot when attached onto the Pivot Rod. Be sure to
stay out of the path of the Handlebar.
Align the Handlebar Arm assembly with the pivot rod and attach the lower
Handlebar Arm assembly fully onto the pivot rod and install the hardware
12. Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
133