Bowflex LateralX LX5 Service Manual page 48

8. Disconnect the cables from the Engine Assembly and the Console
washers (arrows). Remove the Console Mast assembly.
NOTICE: Do not crimp the cables. Do not allow the cable to fall down into
the Engine Assembly. This step may require two people.
9. Installation steps are the reverse procedure.
NOTICE: Do not crimp the Cables. If the Mast Cables are routed through
the Mounting Plate on the Console Mast, pull them back
through the opening. Make sure the Mast Cable connectors do
not fall into the Console Mast. Make sure to connect all cables.
Each connector end can only be connnected to the matching
Mast.
Note: Put the Right Upper Shroud in position. Align the Push Fasteners.
Push the Shrouds together so that the Push Fasteners are fully
seated. Using a #2 Phillips screwdriver, re-install the 3 screws.
Self-tapping screws attach the Shroud to the Frame.
Re-install the Mast Gasket.
Be sure the Handlebar Link is tilted forward. Put the Wave Washer on the
pivot rod.
Be aware that the Handlebar Arms are top heavy, and will
want to pivot when attached onto the Pivot Rod. Be sure to
stay out of the path of the Handlebar.
Align the Handlebar Arm assembly with the pivot rod and attach the lower
Handlebar Arm assembly fully onto the pivot rod and install the hardware
10. Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
X4
48