Bowflex LateralX LX5 Service Manual page 132

6. Using a #2 Phillips Screwdriver, remove the 4 screws that attach the
the top screws (5b). Set the screws safely aside.
Servo wheel
5b (X2)
5a (X2)
7. Using an 8mm open end wrench, loosen the indicated nut (1) on the
Flywheel cable two turns. Observe the routing of the cable around the
white nylon servo wheel. Carefully pull the cable straight down out of the
mounting bracket (2) and move the cable toward the servo wheel. Pull
down to remove the "barrel" end (3) of the cable from its slot (4) on the
servo wheel. Remove the Servo Motor. Set the old Servo Motor safely
aside.
8. Carefully put the "barrel" end (3) of the Flywheel cable in the slot (4) on
the servo wheel on the new Servo Motor. Be sure the cable's path around
the servo wheel is the same as it was on the old Servo Motor. Carefully
push the cable into position in the mounting bracket (2). Using an 8mm
open end wrench, tighten the nut (1) on the Flywheel cable to secure the
cable.
9. Using a #2 Phillips Screwdriver, attach the new Servo Motor to the
10. Carefully connect the Servo Motor cable to the engine cable harness.
NOTICE: Align the clips on the cable connectors and make sure the
connectors lock. Do not crimp the cables.
4
3
Flywheel cable
Flywheel cable routing
Servo wheel
Flywheel
cable
132
2
1
3
2
4