Bowflex LateralX LX5 Service Manual page 28

42. The remaining assembly steps are the reverse procedure.
Note:
Shroud with the Push Fasteners and move the Right Shroud into
position. Push the Shrouds together so that the Push Fasten-
ers are fully seated. Using a #2 Phillips screwdriver, install the 6
screws.
Self-tapping screws attach the Shrouds to the Frame.
Re-install the Mast Gasket.
Be sure the Handlebar Links are tilted forward. Put the Wave Washers on
the pivot rods.
Be aware that the Handlebar Arms are top heavy, and will
want to pivot when attached onto the Pivot Rod. Be sure to
stay out of the path of the Handlebar.
Align the Handlebar Arm assembly with the pivot rod and attach the lower
Handlebar Arm to the Handlebar Link
43. Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
28