Internal Usb Key - Dell PowerEdge FC630 Owner's Manual
Hide thumbs
Also See for PowerEdge FC630:
- Getting started (2 pages) ,
- Owner's manual (143 pages) ,
- Getting started with your system (2 pages)
Table of Contents
Advertisement
Figure 13. Replacing an SD card
1.
IDSDM card
3.
upper card slot (SD 2)
Next steps
1.
Follow the procedure listed in
2.
Enter the System Setup and ensure that the Internal SD Card Port and Internal SD Card
Redundancy mode is enabled.
3.
Check if the new SD card is functioning properly. If the problem persists, see
Internal USB key
The sled provides an internal USB connector for a USB flash memory key. The USB memory key can be
used as a boot device, security key, or mass storage device. To use the internal USB connector, the
Internal USB Port option must be enabled in the Integrated Devices screen of the System Setup.
To boot from the USB memory key, you must configure the USB memory key with a boot image, and
then specify the USB memory key in the boot sequence in the System Setup. For information on creating
After working inside your
Get other manuals https://www.bkmanuals.com
2.
SD card
4.
lower card slot (SD 1)
system.
Getting
Help.
55
Advertisement
Table of Contents
Troubleshooting
