Internal Usb Key - Dell HHB Owner's Manual

Figure 22. Installing an SD card
a. IDSDM card
b. SD card
Next steps
1. Follow the procedure listed in the After working inside your system section.
2. Enter the System Setup and ensure that the Internal SD Card Port and Internal SD Card Redundancy mode is enabled.
3. Check if the new SD card is functioning properly. If the problem persists, see the Getting help section.
Related tasks
Before working inside your system
Troubleshooting an Internal SD Card
After working inside your system
Related reference
Getting help
Safety instructions

Internal USB key

The blade provides an internal USB connector for a USB flash memory key. The USB memory key can be used as a boot device, security
key, or mass storage device. To use the internal USB connector, the Internal USB Port option must be enabled in the Integrated
Devices screen of the System Setup.
To boot from the USB memory key, you must configure the USB memory key with a boot image, and then specify the USB memory key in
the boot sequence in the System Setup. For information on creating a bootable file on the USB memory key, see the user documentation
that accompanied the USB memory key.
Replacing the internal USB key
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that came with the product.
CAUTION: To avoid interference with other components in the blade, the maximum permissible dimensions of the USB
key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
72 Installing and removing blade components