Cisco ONS 15454 Manual page 19

Turning Up a Node
Warning
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work
on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard
practices for preventing accidents. To see translations of the warnings that appear in this publication, refer to
the Regulatory Compliance and Safety Information document for the appropriate Cisco chassis. Statement
274
Warning During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly touch
the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
Warning Class I (CDRH) and Class 1M (IEC) laser products. Statement 1055
Warning Invisible laser radiation may be emitted from the end of the unterminated fiber cable or connector. Do not
view directly with optical instruments. Viewing the laser output with certain optical instruments (for example,
eye loupes, magnifiers, and microscopes) within a distance of 100 mm may pose an eye hazard. Statement
1056
High-performance devices on this card can get hot during operation. To remove the card, hold it by the
faceplate and bottom edge. Allow the card to cool before touching any other part of it or before placing it in
an antistatic bag. Statement 201
Warning The optical Add/Drop cards and ROADM cards need a maximum of 15 minutes to warm up to ambient
temperature, after it is inserted into a shelf. The card configurations or settings are unavailable during this
period.
Caution Always use the supplied electrostatic discharge (ESD) wristband when working with a powered ONS 15454.
For detailed instructions on how to wear the ESD wristband, refer to the
Guide for Cisco CPT and Cisco ONS
Note
For United States installations, complies with the United States Federal Drug Administration Code of Federal
Regulations Title 21, Sections 1040.10 and 1040.11, except for deviations pursuant to Laser Notice No. 50,
dated July 26, 2001.
Note If protective clips are installed on the backplane connectors of the cards, remove the clips before installing
the cards.
Platforms.
NTP-G30 Installing the DWDM Cards
Electrostatic Discharge and Grounding
Turning Up a Node
19