Cisco ONS 15454 Manual page 27

Turning Up a Node
Procedure
Step 1
Open the card ejectors.
Step 2 Slide the card along the guide rails into the correct slot.
Step 3
Close the ejectors.
Step 4 Repeat for any remaining unused card slots.
Stop. You have completed this procedure.
NTP-G34 Installing Fiber-Optic Cables on DWDM Cards and
DCUs
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Warning Class I (CDRH) and Class 1M (IEC) laser products. Statement 1055
Caution
To comply with the Telcordia GR-1089 NEBS, Issue 5 standard, do not use optical fibers with exposed metallic
ferrules. Exposed metallic ferrules may result in ESD damage to the system and can be service affecting.
Note For US installations, complies with the US Federal Drug Administration Code of Federal Regulations Title
21, Sections 1040.10 and 1040.11, except for deviations pursuant to Laser Notice No. 50, dated July 26, 2001.
NTP-G34 Installing Fiber-Optic Cables on DWDM Cards and DCUs
This procedure attaches fiber-optic cables on the
DWDM cards and DCUs.
Fiber-optic cables
Cisco Transport Planner Internal Connections Report
• NTP-G30 Installing the DWDM cards
• NTP-G31 Installing the DWDM Dispersion
Compensating Units
• NTP-G139 Verifying Cisco Transport Planner
Reports and Files
As needed
Onsite
None
Turning Up a Node
27