Cisco ONS 15454 Manual page 12

DLP-G694 Configuring the PSM Card
parameters. To add the ANS parameters, see the
instructions.
Step 6 Click the value of the ANS parameter that you want to modify and enter the new value specified in the
following table. To modify the ANS parameters, see the
15 task for instructions.
Table 2: Values for the ANS Parameters (amplifier)
Port
Slot 16 (OPT-AMP C).Port
COM-RX
Slot 16 (OPT-AMP C).Port
LINE-TX
Slot 16 (OPT-AMP C).Port
LINE-TX
Slot 16 (OPT-AMP C).Port
LINE-TX
Step 7
Click Apply.
Step 8 Click the Provisioning > WDM-ANS > Port Status tabs.
Step 9
Click Launch ANS.
Step 10 In the Apply Launch ANS dialog box, click Yes.
Step 11
In the Launch ANS confirmation dialog box, click OK.
Step 12 In node view (single-shelf mode) or multishelf view (multishelf mode), click the Provisioning > WDM-ANS
> Provisioning tabs.
Step 13 Verify the following in the Results column:
• Success - Changed —The parameter has been successfully changed with the ports in IS.
Step 14 Verify that the Set By column displays t he value "ANS" or "APC" as the application that sets the
ANS parameter.
Step 15 Return to your originating procedure (NTP).
DLP-G694 Configuring the PSM Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Turning Up a Node
12
DLP-G541 Adding an ANS Parameter, on page 14
DLP-G681 Modifying an ANS Parameter, on page
ANS Parameter
Channel LOS Threshold
Amplifier Working Mode
Amplifier Tilt
Power
This tasks configures the PSM behavior.
None
DLP-G46 Log into CTC
As needed
Onsite or remote
Turning Up a Node
task for
Value
35.0 dBm
Control Gain
0.0 dB
1.0 dBm