Cisco ONS 15454 Manual page 14

DLP-G541 Adding an ANS Parameter
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note
It is recommended that you use the Cisco Transport Planner XML configuration file to provision the ANS
parameters instead of manually adding all the parameters in CTC. ANS provisioning parameters must be
manually changed only by Cisco qualified personnel. Provisioning the ANS parameters incorrectly (either as
preamplifier or booster input power thresholds) may impact traffic.
Procedure
As needed, complete the following tasks:
• Complete the
• Complete the
• Complete the
Stop. You have completed this procedure.
DLP-G541 Adding an ANS Parameter
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Procedure
Step 1 In node view (single-shelf mode) or multishelf view (multishelf mode), click the Provisioning > WDM-ANS
> Provisioning tabs.
Turning Up a Node
14
DLP-G541 Adding an ANS Parameter, on page
DLP-G681 Modifying an ANS Parameter, on page
DLP-G542 Deleting an ANS Parameter, on page
None
DLP-G46 Log into CTC
As needed
Onsite or remote
Provisioning or higher
14.
15.
17.
This tasks adds an ANS parameter.
None
DLP-G46 Log into CTC
As needed
Onsite or remote
Provisioning or higher
Turning Up a Node