Cisco ONS 15454 Manual page 17

Turning Up a Node
Step 3
Click Apply.
Step 4 Click the Provisioning > WDM-ANS > Port Status tabs.
Step 5
Click Launch ANS.
Step 6 In the Apply Launch ANS dialog box, click Yes.
Step 7
In the Launch ANS confirmation dialog box, click OK.
Step 8 In node view (single-shelf mode) or multishelf view (multishelf mode), click the Provisioning > WDM-ANS
> Provisioning tabs.
Step 9
Verify the following in the Results column:
• Success - Changed —The parameter has been successfully changed with the ports in IS.
Step 10
Verify that the Set By column displays t he value "ANS" or "APC" as the application that sets the
ANS parameter.
Step 11
Return to your originating procedure (NTP).
DLP-G542 Deleting an ANS Parameter
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Procedure
Step 1
In node view (single-shelf mode) or multishelf view (multishelf mode), click the Provisioning > WDM-ANS
> Provisioning tabs.
Step 2
Click the ANS parameter you want to remove.
Note
Step 3
Click Remove, and then Yes.
Step 4 Return to your originating procedure (NTP).
Only threshold related ANS parameters can be removed if the port is in service state.
DLP-G542 Deleting an ANS Parameter
This tasks removes an ANS parameter.
None
DLP-G46 Log into CTC
As needed
Onsite or remote
Provisioning or higher
Turning Up a Node
17