Cisco ONS 15454 Manual page 11

Turning Up a Node
Menu Item
OSCM
TNC TSC
Note
Note
Step 3 Repeat
Stop. You have completed this procedure.
DLP-G693 Configuring the Amplifier Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Procedure
Step 1 Display the amplifier card in card view.
Step 2
Click the Provisioning > Card tabs.
Step 3 Select the working mode from the Card Working Mode drop-down list.
Step 4
Change to node view (single-shelf mode) or multishelf view (multishelf mode), then click the Provisioning
> WDM-ANS > Provisioning tabs.
Step 5
From the Selector area, select the amplifier slot. If the default parameters are present, continue with
If not, click Add to add the Channel LOS Threshold, Amplifier Tilt, Power, and Amplifier Working Mode
Submenu
Category
—
—
Choose the menu option TNC for TNC, TNCE, or TNCS/TNCS-O pre-provision. The CTC displays
the TNC, TNCE, or TNCS/TNCS-O card name according to the inserted card. Same applies for
TSC card also.
When you pre-provision a slot, the card appears purple in the CTC shelf graphic (the card appears
as white when a card is installed in the slot). NP on the card graphic indicates that the card is not
physically installed.
Step 2 until all the cards shown in the Cisco Transport Planner shelf layout are provisioned in CTC.
Card Group Submenu Item 1
— —
Control Cards —
This task configures the optical parameters and
threshold values of the amplifier card.
None
DLP-G46 Log into CTC
As needed
Onsite or remote
Provisioning or higher
DLP-G693 Configuring the Amplifier Card
Submenu Item 2 Cards
— OSCM (Slots 8
and 10 only)
— TNC, TNCE,
TSC, TSCS, and
TNCS/TNCS-O
Turning Up a Node
Step 6.
11