Cisco ONS 15454 Manual page 68

DLP-G496 Creating an SNMPv3 User
Stop. You have completed this procedure.
DLP-G496 Creating an SNMPv3 User
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Procedure
Step 1
In node view, click the Provisioning > SNMP > SNMP V3 > Users tabs.
Step 2 Click Create.
Step 3 In the Create User dialog box, enter the following information:
• User Name— Specify the name of the user on the host that connects to the agent. The user name must
• Group Name—Specify the group to which the user belongs.
• Authentication
• Privacy—Initiates a privacy authentication level setting session that enables the host to encrypt the
Turning Up a Node
68
• Trap destination on the ENE with an IP address of the GNE as the target IP and 161 as the UDP
port number
• Remote user details of the ENE on the GNE
be a minimum of 6 and a maximum of 40 characters (up to only 39 characters for the TACACS and
RADIUS authentication). It includes alphanumeric (a-z, A-Z, 0-9) characters and the allowed special
characters are @, "-" (hyphen), and "." (dot) . For TL1 compatibility, the user name must be of 6 to 10
characters.
• Protocol—Select the authentication algorithm that you want to use. The options are NONE, MD5,
and SHA.
• Password—Enter a password if you select MD5 or SHA. By default, the password length is set to
a minimum of eight characters.
contents of the message that is sent to the agent.
• Protocol—Select the privacy authentication algorithm. The available options are None, DES, and
AES-256-CFB.
This procedure creates an SNMPv3 user.
None
• DLP-G46 Log into CTC
• DLP-G498 Create Group Access , on page 69
As needed
Onsite
Provisioning or higher
Turning Up a Node