Cisco ONS 15454 Manual page 70

DLP-G499 Configure SNMPv3 Trap Destination
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Procedure
Step 1 In node view, click the Provisioning > SNMP > SNMP V3 > Group Access tabs.
Step 2
Click Create.
Step 3 In the Create Group Access dialog box, enter the following information:
• Group Name—The name of the SNMP group, or collection of users, who share a common access policy.
• Security Level—The security level for which the access parameters are defined. Select from the following
• Views
• Allow SNMP Sets—Select this check box if you want the SNMP agent to accept SNMP SET requests.
Note
Step 4
Click OK to save the information.
Step 5 Return to your originating procedure .
DLP-G499 Configure SNMPv3 Trap Destination
Purpose
Tools/Equipment
Turning Up a Node
70
options:
• noAuthNoPriv—Uses a user name match for authentication.
• AuthNoPriv—Provides authentication based on the HMAC-MD5 or HMAC-SHA algorithms.
• AuthPriv—Provides authentication based on the HMAC-MD5 or HMAC-SHA algorithms. Provides
DES 56-bit encryption based on the CBC-DES (DES-56) standard, in addition to authentication.
If you select authNoPriv or authPriv for a group, the corresponding user must be configured with
an authentication protocol and password, with privacy protocol and password, or both.
• Read View Name—Read view name for the group.
• Notify View Name—Notify view name for the group.
If this check box is not selected, SET requests are rejected.
SNMP SET request access is implemented for very few objects.
None
• DLP-G46 Log into CTC
As needed
Onsite
Provisioning or higher
This procedure configures SNMPv3 trap destination.
None
Turning Up a Node