Cisco ONS 15454 Manual page 2

NTP-G341 Setting Up Secure Access to TL1
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
NTP-G341 Setting Up Secure Access to TL1
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Procedure
Step 1 In the node view, click the Provisioning > Security > Access pane.
Step 2 Under the TL1 Access area, change the Access State to Secure.
Step 3 Click Apply.
Existing non-secure TL1 sessions, if any, are terminated.
Step 4 To create a secure TL1 connection, enter the following command at the UNIX or Linux prompt:
ssh -l username node-ip -p port-number
Turning Up a Node
2
OpenSSH Version, on page 3
NTP-G29 Setting Up SNMP, on page 3
NTP-G328 Adding, Modifying, or Deleting ANS Parameters, on page 13
NTP-G30 Installing the DWDM Cards, on page 18
NTP-G179 Installing the Transponder and Muxponder Cards, on page 22
NTP-G123 Installing the Filler Cards, on page 26
NTP-G34 Installing Fiber-Optic Cables on DWDM Cards and DCUs, on page 27
NTP-G140 Installing Fiber-Optic Cables Between Terminal, Hub, or ROADM Nodes, on page 31
NTP-G185 Installing Fiber-Optic Cables between Mesh Nodes, on page 49
NTP-G191 Installing Fiber-Optic Cables on Passthrough ROADM Nodes, on page 53
NTP-G141 Installing Fiber-Optic Cables for Y-Cable Protection Modules, on page 55
NTP-G39 Verifying OSCM Transmit Power, on page 60
NTP-G210 Provisioning Node for SNMPv3, on page 63
NTP-G211 Provisioning Node to Send SNMPv3 Traps, on page 63
NTP-G212 Manually Provisioning a GNE/ENE to Manage an ENE using SNMPv3, on page 64
NTP-G213 Automatically Provisioning a GNE to Manage an ENE using SNMPv3, on page 65
NTP-G214 Manually Provisioning a GNE/ENE to Send SNMPv3 Traps using SNMPv3, on page 66
NTP-G215 Automatically Provisioning a GNE/ENE to Send SNMPv3 Traps Using SNMPv3, on page
67
NTP-G355 Provisioning OTDR , on page 79
This procedure provisions the nodes for secure access
to TL1.
None
NTP-G26 Set Up CTC Network Access
As needed
Onsite or remote
Superuser
Turning Up a Node