6.2. Intersecting axis gear
Everyday before starting work please check the oil level and, if needed, please refill after having
removed the vent A on the top of the gear (Fig. 22.). The oil level can be checked through the check
opening B on the side of the gear. Please refill the oil until it is visible in the check opening B. The oil
capacity: about 1 l.
Fig. 22. Intersecting axis gear lubrication point.
Tab.4. Oil capacities
Model
Oil capacity [l]
All models
CAUTION:
The above instructions should be strictly followed. If the discs in the
cutterbar rotate loosely, do not worry about the high intersecting axis
gear temperature; after long working time it may reach even 60-80
6.3. Roller conditioner's gearbox
Before you check the lubrication of the gearbox, please remove the safety guard. Everyday before
starting work please check the oil level and, if needed, please refill after having removed the vent A on
the top of the gearbox (Fig. 23) The oil level can be checked through the check opening B on the side
of the gear. Please refill the oil until it is visible in the check opening B. The oil level: about 0,5 l.
Check oil level when the cutterbar is on the ground. Removing the worked oil from the gearbox is
done through the outlet C.
Operator's manual
A
B
(acc. to ISO 3448 oil viscosity grade :
about 1
KDF 260 S/W; KDF 300 S/W;
Oil type
VG-680 – 1000 )
22
Front disc mower
KDF 260; KDF 300;
A
Lubrication frequency
Once every 3 seasons
(if working intensively)
o
C.