adjust the space between
the frame suspension and
rubber safety bumper to
about. 15 cm.
Shafts end with
overrunning clutch.
Fig. 4. Proper mounting of the mower on tractor's triangle cat. II (model without tine/roller
conditioner).
4.2. Adjusting the clearance between triangle's hook and lock
After the mower has been mounted and lifted and the clearance between triangle's hook and lock has
more than 1 mm (fig. 5a.), please do the following:
Upper link
Chain
regulating
holes
Fig.5.Mounting the
mower on the 3-
point linkage
frame
Operator's manual
Block the hook with
cotter pin.
~ 15 cm
Block the pin.
Shafts end with
friction clutch.
CAUTION:
Different mounting of the PTO shaft may damage PTO shaft,
intersecting axis gear etc.
Mower's triangle
Tractor's triangle
Fig.6. Mower's and tractor's
triangles should be in
parallel
Front disc mower
KDF 260 S/W; KDF 300 S/W;
Adjust the mower in parallel to the ground
by means of upper link.
W
Adjust, mount and block the
support chain.
a
11
KDF 260; KDF 300;
A-A
Fig.4a
Widok „W"
3
Fig.4b
3
Fig.7. Adjusting the lock
1
2
a
block
A
1
2
b
A
Lock
regulation
1
2