Transport And Working Positions; Mounting The Mower On Tractor's Triangle Cat. Ii - SaMASZ KDF 260 Operator's Manual

4. TRANSPORT AND WORKING POSITIONS

4.1. Mounting the mower on tractor's triangle cat. II

CAUTION:
The manufacturer is not responsible for mower's damage, if it is caused
by improper mounting.
Unmounting of the mower may cause the following damages:
- bending of mower's guards by the tractor,
- damage of PTO shaft,
- damage of the gear and other parts of the mower.
During operation check mounting of the mower.
The mower is mounted on the tractor's triangle which is connected to the tractor's front
3-point linkage (the tractor's triangle cat. II is NOT a part of standard equipment – it
can be ordered from SaMASZ as optional extra equipment).
When the triangle is connected to the tractor's 3-point linkage, adjust it (by means of
upper link) in parallel to the mower's triangle, lift the 3-point linkage until it locks in,
check the space between (1) triangle's hook and pawl (2) (fig. 4a.), block the hook (1)
with cotter pin ∅4 (2) (fig. 4b.), adjust the space between the frame suspension and a
rubber safety bumper to about 150 mm (fig. 4), regulate and mount support chains,
block them with cotter pins according to 4.3.
Operator's manual
WORKING WITHOUT SAFETY GUARDS
Caution
rotor
Front disc mower
KDF 260; KDF 300;
KDF 260 S/W; KDF 300 S/W;
IS FORBIDDEN
DANGER OF THE STONES, ETC. BEING
THROWN OUT
max = 1050
min = 900
10
1
/min
1
/min