Daily Maintenance; After-Season Maintenance; Lubrication; Cutterbar - SaMASZ KDF 260 Operator's Manual

5.6.3.Daily maintenance

Everyday after work please carry out the following maintenance:
remove grass and mud,
check all visible units and parts and their connections; tighten all loose bolts and nuts and replace
all damaged and/or worn parts with new genuine ones,
check the cutterbar,
grease PTO shaft tubes with STP grease,
if necessary, lubricate the parts and units according to lubrication instructions (chapter 6.).

5.6.4.After-season maintenance

At the end of the season the mower should be cleaned, washed and dried. Carefully grease unpainted
surfaces and 3-point linkage pins.
After that the following work should be carried out:
Remove any traces of rust and paint the area affected.
Check lubrication of intersecting axis gear and cutterbar. If leaks occur, remove them immediately.
If water is discovered in the oil, it must be changed, otherwise the gears, bearings and shafts could
be damaged.
6.

LUBRICATION

6.1. Cutterbar

Refilling the oil of the cutterbar is done through the inlet A (Fig. 21a.). Proper oil level is 5÷7 mm
from the cutterbar bottom. Oil capacities are show in tab. 3. Removing the worked oil from the
cutterbar is done through the outlet B (Fig. 21b. ) situated at the end of the cutterbar. Always change
the oil just after finished work, when it is still warm.
A
a
Fig. 21. Cutterbar oil inlet (A) and outlet (B)
Tab.3. Oil capacities.
Model
KDF 260 – 2,6 m;
KDF 260 S – 2,6 m
KDF 260 W – 2,6 m;
KDF300 – 3,0 m
KDF 300 S – 3,0 m
KDF300W – 3,0 m
Operator's manual
Oil capacity [L]
6,5
7,0
Front disc mower
KDF 260; KDF 300;
KDF 260 S/W; KDF 300 S/W;
b
Oil type
80W90
21
B
Lubrication frequency
Once every 3 seasons
(if working intensively)