Erecting Transmitter Rack; Aligning Transmitter Rack; Fastening The Transmitter Rack To The Floor; Removing Front Panels/Rear Panel - R&S N 8000 Series System Manual

3.2

Erecting Transmitter Rack

The transmitter rack can be set up using lift equipment (crane). Lifting eyes are attached to
the rack roof for this purpose.
Fig. 3 Lifting eyes
WARNING!
Do not stand under suspended racks, otherwise you could be crushed.
Take the relevant safety precautions when climbing ladders, otherwise you could fall.
3.3

Aligning Transmitter Rack

The rack must be aligned vertically and horizontally in order to prevent distortion caused by
shearing forces.
 Use a spirit level to align the rack.
Using the height-adjustable rack feet, align the rack such that it is vertical and horizontal
along all axes.
3.4

Fastening the Transmitter Rack to the Floor

If required the transmitter rack can be screwed to the floor or to a floor-frame. Two 12-mm
boreholes are provided in the lower crossbeam of the transmitter rack for this purpose.
3.5

Removing Front Panels/Rear Panel

Before you start installing the individual units, make sure that you have easy access to all
units, connectors and interfaces needed.
2098.0188.72
Chapter 3
- 3.7 -
Installation
E-1