Overview - R&S N 8000 Series System Manual

2

Overview

The transmitter is installed by following the sequence given below:

Setting up the transmitter
– Checking the structure, flatness and general suitability of the installation surface
– Preparing openings required in the floor (only with inlets and outlets from below)
– Arranging the connections on the transmitter roof
– Erecting the transmitter rack
– Aligning the transmitter rack
– Bolting the transmitter rack to the floor
– Removing the front panels/rear panel
– Unpacking the components

Ventilation system
– Connecting the intake/exhaust air ducts
– Connecting the external backup fan (optional)
– Checking the ventilation covers

AC power supply
– Connecting the transmitter ground
– Connecting the power cable
– Connecting the external units

Installing the amplifiers

RF output
– Connecting the antenna
– Connecting the dummy antenna

Program feed/remote (connection panel)
A detailed description of the installation procedure is provided in the following chapters.
2098.0188.72
Chapter 3
- 3.3 -
Installation
E-1