5. Check the status of the warning and fault indicators.
If a transmitter is ready to operate, no warnings or faults will be signaled.
3.2
Adjusting Amplifier Order Numbers to Installation
Positions in Rack
After the transmitter system has been put into operation, entries for the amplifiers (of a par-
ticular rack) are displayed in the menu path for the output stage with consecutive numbering
(Amplifier 1 to max. Amplifier 10). Since the numbering is derived from the chronological
sequence in which the amplifiers can be detected on the CAN bus, it does not always cor-
respond to the sequence in which the amplifiers are physically arranged from top (= 1) to
bottom (= n) in the rack.
To make association between menu and amplifier easier, the entries can be sorted.
1. Select Outputstage A > Setup > Rack Setup > Rack 1 > Amplifier Order.
The Amplifier Order window opens.
2098.0188.72
Chapter 4
- 4.29 -
Commissioning
E-1