Preparing For Transmitter Startup; Preparing For Local Operation; Checking And Setting System And Operating Parameters; R&S Netccu800 - R&S N 8000 Series System Manual

2

Preparing for Transmitter Startup

Local operation of the R&S NetCCU800 includes all the information calls for the system pa-
rameters and their settings, complete with intuitive graphical menus.
Remote operation via a web browser is possible only if a PC or notebook is connected to
the front panel of the R&S NetCCU800.
2.1

Preparing for Local Operation

To prepare for local control, proceed as follows:
 Press the
Its yellow LED should light up.
2.2 Checking and Setting System and Operating
Parameters
In order to bring the transmitter into operation, you must check and set the following system
and operating parameters.
2.3 R&S NetCCU800
2.3.1 Switching On R&S NetCCU800
 Connect the R&S NetCCU800 to the AC power supply.
After a few seconds, the unit boots up and the entry screen indicates when it is ready for
use.
Local operation of the R&S NetCCU800 includes all the information calls for the system pa-
rameters and their settings, complete with intuitive graphical menus.
Remote operation via a web browser is possible only if a PC or notebook is connected to
the front panel of the R&S NetCCU800.
2.3.2

Changing User Type

To configure the transmitter by means of the R&S NetCCU800, you must have configuration
rights.
2098.0188.72
Chapter 4
LOCAL key on the R&S NetCCU800.
- 4.3 -
Commissioning
E-1