Rear Ethernet Interface (Netlink) - R&S N 8000 Series System Manual

 Select NetCCU > Setup > NetCCU Setup > Network > Front Ethernet.
The Front Ethernet window opens.
The Front Ethernet window displays the following network settings:
Display
IP Address
Network Mask
Speed Mode
Autosensing
MAC Address
Notes
All settings for the front Ethernet interface are preset. If a PC/laptop is to be connected, the
network interface on the PC/laptop must be configured accordingly:
– IP address (PC): First three segments same as those for IP Address of the R&S
NetCCU800 (see above); a value below 250 must be entered for the last segment
– Subnet mask (PC): Same settings as under Network Mask (see above)
2.3.5.2

Rear Ethernet Interface (NETLINK)

Configure the
to connect the transmitter to a LAN/WAN.
2098.0188.72
Chapter 4
Explanation
IP address of the network card
Subnet mask of the network card
Speed and duplex
Factory setting: 10 Mbit / half duplex
Autonegotiation ON/OFF
Factory setting: On
Autonegotiation = Automatic determination of the settings for the net-
work card
Unique ID of the network card
NETLINK interface (X5) on the rear panel of the R&S NetCCU800 if you want
- 4.7 -
Commissioning
E-1