Configuring Input Interfaces; Specifying Data Format For Data Streams Input 1 And Input 2 - R&S N 8000 Series System Manual

2.5.2

Configuring Input Interfaces

2.5.2.1

Specifying Data Format for Data Streams Input 1 and Input 2

1. Select Exciter A ATSC > Input > Input Config.
The Input > Input Config window opens.
2. Go to Presel. Mode and select the value Auto for Input1 and Input2.
The data format is recognized automatically.
The table below describes the parameters in detail:
Setting item
Presel. Mode
[Input 1/Input 2]
Display
Packet Length
[Input 1/Input 2]
Meas.Data Rate [bps]
[Input 1/Input 2]
Req. Data Rate [bps]
[Input 1/Input 2]
Active Mode
2098.0188.72
Chapter 4
Explanation
Sets the data format for the two data streams (main and standby sig-
nals) on inputs TS 1 IN or TS 2 IN.
The options are as follows:
– AUTO: The data format is recognized automatically
– ASI: Manual setting for an ASI transport stream
– SMPTE: Manual setting for an SMPTE transport stream
Explanation
Displays the packet length detected at the respective input
Displays the data rate measured at the respective input without null
packets
Display for checking the measured data rate. The maximum data pro-
cessing rate is displayed.
Displays the data format detected or set at the respective input:
– ASI: As described
– SMTPE: As described
– AUTO: Auto is selected and there is no data stream
- 4.12 -
Commissioning
E-1