Adjusting Network Settings; Front Ethernet Interface - R&S N 8000 Series System Manual

1. Select NetCCU > Setup > NetCCU Setup > Date/Time.
The Date/Time window opens.
2. Enter the basic settings as shown in the table below.
Setting item
Date
Local Time
UTC Time Offset
2.3.5

Adjusting Network Settings

In the windows of the Network menu, you can make network settings and obtain informa-
tion about current settings.
2.3.5.1

Front Ethernet Interface

The ETHERNET
PC/laptop. Find out about the factory settings for this interface if you want to operate the
transmitter "remotely" using a connected PC.
2098.0188.72
Chapter 4
Explanation
Used to set the current date
Used to set the local time
The local time is the time of day or zone time applicable at the station.
Unlike universal time (UTC = universal time coordinated), there is a pos-
itive offset for time zones east of Greenwich or a negative offset for time
zones west of Greenwich.This offset is determined by the time zone and
is always a multiple of a full hour or sometimes of a half hour.
In some countries, the clock is set forward by 1 hour in summer (daylight
saving time). The time offset relative to UTC then changes correspond-
ingly.
Used to enter the time offset between local time and UTC
interface on the front panel of the R&S NetCCU800 is used to connect a
- 4.6 -
Commissioning
E-1