2.5
Entering Exciter Settings
2.5.1
Setting TV Standard
1. Select Exciter A ATSC > Setup > Exciter Setup > Common.
The Exciter Setup > Common window opens.
2. Select the required TV standard.
The table below describes the parameters in detail:
Setting item
Digital Standard
a) To reboot the exciter, disconnect it briefly from the AC power supply or execute the Reboot Tx command in
the Tx Setup context menu.
Display
Amplifier Control
2098.0188.72
Chapter 4
Description
Selection of the digital TV standard: DVB-T, DVB-H or ATSC
To switch over from DVB-T or DVB-H to ATSC you need to reboot
exciter. At the same time signal processing is switched over and the
associated user interface is loaded.
Description
Status display for amplifier control
In R&S low-power transmitters, the exciter takes over amplifier control.
- 4.11 -
Commissioning
a)
the
E-1