Setting Rf Output - R&S N 8000 Series System Manual

2.5.6

Setting RF Output

1. Select Exciter A ATSC > RF > Output.
The RF > Output window opens.
2. For normal transmission operation, enter the following settings:
Setting item
Regulation
Output Attenuation
RF Slope
Modulation Slope
The table below describes the adjustable parameters in detail:
Setting item
RF Output
Regulation
Manual RF Level
Output Attenuation
2098.0188.72
Chapter 4
Setting
ON
0 dB
0 %
0 %
Description
Enables (On) or disables (Off) the RF output.
Activates (On) or deactivates (Off) the output level control. During trans-
mission operation, control must be enabled.
The current status of the related level adjuster is displayed as a percent-
age under RF > RF Monitor > AGC Exciter.
Manual setting of the output level; the setting has an effect only if output
level control is deactivated.
The current status of the related level adjuster is displayed as a percent-
age under RF > RF Monitor > AGC Exciter.
For level adaptation purposes, an integrated attenuator with a value of
3 dB, 6 dB or 9 dB can be connected. This has no influence on the level
control.
- 4.17 -
Commissioning
E-1