Setting Date And Time - R&S N 8000 Series System Manual

2. Enter the basic settings as shown in the table below.
Function
Display Timeout
LED Local
LED On
Fan Control
Tx Name
2.3.4

Setting Date and Time

The date and precise time are required to make correct logbook entries. This information is
supplied by the internal clock of the R&S NetCCU800. If necessary, the time and date can
be corrected in the Date/Time menu window.
Using NTP
You can change directly to the NTP menu window from the context menu. With NTP, the
local time is determined via NTP and a time set manually under Local Time is overwritten.
Function
Setup NTP
2098.0188.72
Chapter 4
Explanation
Time in minutes after which the display switches off (standby)
Color of the Local LED on the front panel of the R&S NetCCU800 (yel-
low, green)
Color of the ON LED on the front panel of the R&S NetCCU800 (yellow,
green)
Used to switch the fan monitoring function on and off; the fan monitoring
function must be switched off for instruments without fans.
User-definable name for the transmitter; is displayed in the login screen
and in the browser window
Explanation
Used to change directly to the NTP menu window
- 4.5 -
Commissioning
E-1