R&S N 8000 Series System Manual page 113

8 Connection Panel
The following table lists all the connectors that you may need to assign.
Connection
CANBUS X101A
CANBUS X101B
RS232 X232
ETHERNET
ANTENNA 1 INPUT
ANTENNA 2 INPUT
TS1 / TS2
TS3 / TS4
10 MHz REF INPUT
1PPS MONITORING
1PPS EXT INPUT
TS1/2 MONITORING
TS3/4 MONITORING
2098.0188.72
Chapter 3
Description
CAN bus data connection for additional racks or output stage A
CAN bus data connection for additional racks or output stage B
Serial data connection for external BITBUS interface
Remote LAN connector or system LAN connector, e.g. for N+1
Antenna connection for receiver module input 1 in R&S NetCCU800
(DVB-T only)
Antenna connection for receiver module input 2 in R&S NetCCU800
(DVB-T only)
Transport stream inputs
Additional connections for TS1 and TS2 with hierarchical coding
(DVB-T only)
Input for 10 MHz reference for synchronization of output signal
Test output 1PPS (1PPS = 1 pulse per second)
Input for 1PPS signal, reference signal in SFN mode
Monitor output for selected TS signal of inputs 1 and 2
Monitor output for selected TS signal of inputs 3 and 4 (DVB-T only)
- 3.23 -
Installation
E-1