R&S N 8000 Series System Manual page 126

1. Select NetCCU > Setup > NetCCU Setup > Network > Rear Ethernet.
The Rear Ethernet window opens.
2. Make the required settings:
Setting/display
IP Address
Network Mask
Gateway
DHCP Client
Speed Mode
Autosensing
MAC Address
a) Caution: Only change the settings for Speed Mode and Autosensing in exceptional cases where there are
problems with the network connection.
2098.0188.72
Chapter 4
Explanation
IP address of the network card
Subnet mask of the network card
Gateway address (specified by the network administrator)
Switch used to activate/deactivate the DHCP client:
– On: The network settings for IP address, subnet mask and gateway
are retrieved automatically by a DHCP server
– Off: The network settings for IP address, subnet mask and gateway
must be entered manually (see above)
a)
Speed and duplex
Factory setting: 100 Mbit / full duplex
a)
Autonegotiation ON/OFF
Factory setting: On
Autonegotiation = Automatic determination of the settings for the net-
work card
Unique ID of the network card
- 4.8 -
Commissioning
E-1