Drive System Maintenance; Maintaining The Tires - Toro Workman MDX-D Operator's Manual

Adjusting the Headlights
Use the following procedure to adjust the headlight
beam position whenever a headlight assembly is
replaced or removed.
1. Turn the key switch to the O
on the headlights.
2. At the back of the headlight assembly, rotate
adjustment screws
headlight assembly and align the position of the
cast beam.
position, and turn
N
(Figure 43) to pivot the
Drive System
Maintenance

Maintaining the Tires

Service Interval: Every 100 hours—Check the
condition of the tires and rims.
Every 100 hours—Torque the wheel-lug nuts.
1. Inspect the tires an rims for signs of wear and
damage.
Note:
Operating accidents, such as hitting
curbs, can damage a tire or rim and also disrupt
wheel alignment, so inspect tire condition after
an accident.
2. Torque the wheel-lug nuts to 108 to 122 N∙m (80
to 90 ft-lb).
41