Toro Workman MDX-D Operator's Manual page 40

CAUTION
The bulbs become extremely hot when in
operation. Handling a hot bulb can cause
severe burns and personal injury.
Always allow enough time to for the bulbs
to cool before replacing them. Use care
whenever handling the bulbs.
Specification: See your Parts Catalog.
1. Disconnect the battery; refer to
the Battery (page
2. Open the hood.
3. Disconnect the electrical connector for the
harness from the connector of the lamp
assembly at the back of the headlight housing
(Figure 42).
Figure 42
1. Headlight housing
2. Lamp assembly
4. Rotate the lamp assembly 1/4 turn
counterclockwise and moving it rearward,
out of the headlight housing
5. Insert the new lamp assembly and headlight
housing and align the tabs in the lamp assembly
with the slots in the headlight housing
42).
6. Secure lamp assembly by turning it 1/4 turn
clockwise (Figure
7. Connect the electrical connector for the harness
to the connector of the new lamp assembly
(Figure 42).
8. Connect the battery and close the hood; refer to
Connecting the Battery (page
Disconnecting
38).
3. Harness-electrical
connector
(Figure 42).
(Figure
42).
39).
Replacing the Headlight
1. Disconnect the battery; refer to
the Battery (page
2. Open the hood; refer to
30).
3. Disconnect the electrical connector for the
harness from the connector of the lamp
assembly
1. Speed clip
2. Opening in the bumper
3. Adjustment screw
4. Remove the speed clips that secure the
headlight to the headlight bracket
g036872
Note:
Retain all parts for installation of the new
headlight.
5. Remove the headlight assembly by moving it
forward through the opening in the front bumper
(Figure 43).
6. Install the new headlight through the opening in
the bumper
Note:
Ensure the adjustment posts are lined up
with the holes in the mounting bracket behind
the bumper.
7. Secure the headlight assembly with the speed
clips that you removed in step 4.
8. Connect the electrical connector for the harness
to the connector of the lamp assembly
43).
9. Adjust the headlights to direct the beams to
the desired position, refer to
Headlights (page
40
Disconnecting
38).
Closing the Hood (page
(Figure 43).
Figure 43
4. Headlight
5. Lamp assembly
6. Harness-electrical
connector
(Figure 43).
Adjusting the
41).
g036873
(Figure 43).
(Figure