Toro Workman MDX-D Operator's Manual page 36

Figure 37
1. Engine-oil filter
6. Remove the drain plug
Note:
Allow the oil to completely drain from the
engine.
Note:
Dispose of the used oil at a certified
recycling center.
7. Install the drain plug and seal
torque the plug to 45 to 53 N∙m (33 to 39 ft-lb).
8. Clean around the oil dipstick and fill cap, and
remove the dipstick
Figure 38
1. Fill cap
2. Engine-oil-drain plug
(Figure 37).
(Figure 37) and
(Figure 38).
2. Dipstick
9. Pour oil into the fill opening until the oil level is
up to the Full mark on the dipstick.
10. Add the oil slowly and check the level often
during this process.
Note:
Do not overfill the engine with oil.
11. Install the oil-fill cap and dipstick firmly in place.
Changing the Engine-Oil Filter
Service Interval: After the first 50 hours
Every 150 hours/Yearly (whichever comes first)
Change the oil twice as often during special
operating conditions.
1. Drain the oil from the engine; refer to steps
g027838
through 7
(page 21).
2. Remove the existing oil filter
3. Apply a light coat of clean oil to the new filter
gasket.
4. Thread the new filter onto the filter adapter until
the gasket contacts the mounting plate, then
tighten the filter an additional 1/2 to 3/4 turn
further (Figure
Note:
Do not overtighten the oil filter.
5. Fill the crankcase with the specified oil
36).
6. Start and run the engine to check for leaks.
7. Shut off the engine and check the oil level.
Note:
If necessary, add the specified oil into
the engine until the oil level is at the Full mark
on the dipstick.
g016858
36
in Checking the Engine-Oil Level
(Figure
37).
1
37).
(Figure