Checking The Fluid Levels And Tire; Pressure - Toro Workman MDX-D Operator's Manual

2
Connecting the Battery
(Model 07236TC Only)
No Parts Required
Procedure
WARNING
Incorrect battery-cable routing could damage
the machine and cables, causing sparks.
Sparks can cause the battery gasses to
explode, resulting in personal injury.
• Always disconnect the negative (black)
battery cable before disconnecting the
positive (red) cable.
• Always connect the positive (red) battery
cable first.
1. Squeeze the battery cover to release the tabs
from the battery base
1. Battery cover
2. Remove the battery cover from the battery base
(Figure 4).
3. Install the positive-battery cable (red) onto the
positive (+) terminal of the battery and secure
the cable with the bolts and nuts
(Figure 4).
Figure 4
(Figure
1. Insulator boot
(positive-battery cable)
2. Negative-battery post
4. Slide the insulator boot over the positive
terminal.
Note:
possible short-to-ground from occurring.
5. Install the negative-battery cable (black) onto the
negative (–) terminal of the battery and secure
the cable with bolts and nuts.
6. Align the battery cover to the battery base
(Figure
7. Squeeze the battery cover, align the tabs to
the battery base, and release the battery cover
(Figure
3
Checking the Fluid Levels
and Tire Pressure
No Parts Required
g033851
Procedure
1. Check the engine-oil level before and after you
operate the engine for the first time; refer to
Checking the Engine-Oil Level (page
2. Check the brake-fluid level before you operate
the engine for the first time; refer to
the Brake-Fluid Level (page
5).
3. Check the transaxle-fluid level before you
operate the engine for the first time; refer to
Checking the Transaxle-Fluid Level (page
4. Check the air pressure in the tires; refer to
Checking the Tire Pressure (page
11
Figure 5
3. Negative-battery cable
The insulator boot is used to prevent a
4).
4).
20).
g033852
21).
Checking
43).
22).