Checking The Engine-Oil Level - Toro Workman MDX-D Operator's Manual

Figure 17
1. Brake-fluid reservoir
4. If the fluid level is low, preform the following:
A. Clean the area around the reservoir cap
and remove the cap
B. Add DOT 3 brake fluid to the reservoir until
the fluid level is above the Minimum line
(Figure 17).
Note:
Do not overfill the reservoir with
brake fluid.
C. Install the reservoir cap
5. Close the hood of the machine.
Checking the Engine-Oil
Level
Service Interval: Before each use or daily Check the
oil level in the engine before the
engine is first started.
Note:
The machine is shipped with oil in the
crankcase; however, check the oil before and after
you start the engine.
Oil Type: Detergent oil (API service CH-4, CI-4, CJ-4,
or higher)
Viscosity: See the table below
Figure 18
1. Move the machine to a level surface.
g002136
2. Minimum line
(Figure 16).
(Figure 16).
g017503
2. Raise the cargo box; refer to
Box (page 18).
3. Use a rag to clean around the oil dipstick
19) so that dirt cannot fall into the dipstick tube
and damage the engine.
1. Fill cap
4. Remove the oil dipstick and wipe the end clean.
5. Slide the oil dipstick into the dipstick tube fully
seating it (Figure
6. Pull the dipstick out and look at the end
19).
Note:
If the oil level is low, remove the filler
cap from the engine and add the specified oil to
raise the level up to, but not over, the Full mark
on the dipstick. Add the oil slowly and check the
level often during this process. Do not overfill
the engine with oil..
7. Install the oil dipstick and firmly seat it
19).
8. Lower the cargo box; refer to
Cargo Box (page
21
Raising the Cargo
Figure 19
2. Oil dipstick
19).
(Figure
Lowering the
19).
(Figure
g016858
(Figure