Replacing The Fuses; Maintaining The Headlights - Toro Workman MDX-D Operator's Manual

Installing the Battery
1. Align the battery to the battery tray of the
machine (Figure
Note:
Ensure that the positive and negative
posts of the battery are aligned as shown in
Figure 40.
2. Secure the battery to the battery tray with the
battery clamp, carriage bolt, and locknut
40).
3. Connect the battery cables; refer to
the Battery (page
Connecting the Battery
1. Connect the positive battery cable to the terminal
of the battery (Figure
2. Connect the negative battery cable to the
terminal of the battery
3. Install the battery cover onto the top of the
battery (Figure 40).
Charging the Battery
WARNING
Charging the battery produces gasses that
can explode.
Never smoke near the battery and keep sparks
and flames away from battery.
Important:
Always keep the battery fully charged
(1.260 specific gravity). This is especially
important to prevent battery damage when the
temperature is below 0°C (32°F).
1. Remove the battery from the machine; refer to
Disconnecting the Battery (page
2. Connect a 3 to 4 A battery charger to the battery
posts. Charge the battery at a rate of 3 to 4 A
for 4 to 8 hours (12 V).
Note:
Do not overcharge the battery.
3. Install the battery in the chassis; refer to
Installing the Battery (page
Storing the Battery
If you are storing the machine for more than 30 days,
remove the battery and charge it fully. Either store
it on the shelf or on the machine. Leave the cables
disconnected if it is stored on the machine. Store
the battery in a cool atmosphere to avoid quick
deterioration of the charge in the battery. To prevent
the battery from freezing, make sure that it is fully
charged.
40).
Connecting
39).
40).
(Figure 40).
38).
39).

Replacing the Fuses

There are 7 fuses in the electrical system. They are
located beneath the hood
Alarm/Power Point
Engine
Headlights
(Figure
Machine fuse
Lift
Rear lift
Horn
1. Fuse block

Maintaining the Headlights

Replacing the Bulbs
CAUTION
If you install a higher wattage bulb than the
system is designed for, you may damage the
12 V power supply, or at a minimum, blow the
fuse.
Always use the specified Toro LED bulb to
prevent this issue.
39
(Figure 41).
Figure 41
2. Ground block
10 A
10 A
10 A
15 A
15 A
15 A
30 A
g036871